MWC PART 7 - MANIC WRISTWATCH CO-FORMULATION

[is that my watch]

Me and one of the lads were just messing about in the office and this just happened..........


Sharky, any ideas mate ?


Sent from my iPhone using Tapatalk

well got a crystal remover I never use you can have and you could pop out that one measure it and buy a replacement crystal and using the tool pop it in the case in theory

[Smeagal]

Me and one of the lads were just messing about in the office and this just happened..........


Sharky, any ideas mate ?


Sent from my iPhone using Tapatalk

Looks like a hammer hit it, grown men fooling around

[is that my watch]

reckon corner of a table ?

[The Watch Smeller]

well got a crystal remover I never use you can have and you could pop out that one measure it and buy a replacement crystal and using the tool pop it in the case in theory

That's very good of you mate thank you. I could just borrow it and post it back to you when I've finished. Not sure how to replace a crystal though, is it hard work ?


Sent from my iPhone using Tapatalk

[The Watch Smeller]

reckon corner of a table ?

You wouldn't believe me if I told you


Sent from my iPhone using Tapatalk

[The Watch Smeller]

Looks like a hammer hit it, grown men fooling around

You're right about the grown men fooling about bit


Sent from my iPhone using Tapatalk

[underwatermechanic]

Me and one of the lads were just messing about in the office and this just happened..........


Sharky, any ideas mate ?


Sent from my iPhone using Tapatalk

Ouch

That's a bit more than a poly watch job

Sent from my Nexus 7 using Tapatalk

[is that my watch]

That's very good of you mate thank you. I could just borrow it and post it back to you when I've finished. Not sure how to replace a crystal though, is it hard work ?


Sent from my iPhone using Tapatalk

can I be honest have never tried to do one in the sense of this did have an old pop out pop a new one in but they was not pressure seal so to speak they snapped in .. where with that one as design to be under pressure you would need to use a tool on it so ..will post it out sat or Monday mate am sure there are a load of videos on utube on how to replace the crystal

[The Watch Smeller]

can I be honest have never tried to do one in the sense of this did have an old pop out pop a new one in but they was not pressure seal so to speak they snapped in .. where with that one as design to be under pressure you would need to use a tool on it so ..will post it out sat or Monday mate am sure there are a load of videos on utube on how to replace the crystal

I wonder if Sharky knows how it fits in ? It's the compressor that he put together.


Sent from my iPhone using Tapatalk

[is that my watch]

yeah maybe but would think came as a completely case .. the basic is the tool widens the case or shrinks the crystal and then as you unscrew the tool it then tightens in to the case

it seems you clamp it to the out side of the crystal and then as you tighten the tool is squeezes the crystal making it easier to remove